Johnson Controls PCG4B601002X4 5T Gas Heat 14 SEER 1 Phase 208/230 V AC

Features/Benefits:

• Operating Efficiency – All PCG4 model gas units provide a minimum AFUE of 81% in heating and 14 SEER, 11 EER rating for cooling operation
• All models meet California Low-Nox requirements of 40 ng per joule emission level for Air Quality Management Districts
• On Site Flexibility – All model sizes use a compact design cabinet in one of two footprints
• This provides installer flexibility for placing the proper capacity unit on curbs or pads with the smallest footprint after the internal load has been determined
• Field convertible duct connections from side shot to down shot allows the installer to have greater flexibility with less inventory
• Lower Installation Cost – Installation time and costs are reduced by easy power and control wiring connections
• The small base dimension means less space is required on the ground or roof
• All units are completely wired, charged with R-410A and tested prior to shipment
• Test stations using a state-of-the-art computerized process system are used to insure product quality
• Refrigerant charge and component part numbers are verified via computers during assembly
• Vital run test statistics such as system pressure, motor currents, air velocity and temperature, unit vibration and gas system safeties are monitored and recorded by the system to insure unit performance
• Equal size side supply and return duct connections allow easy connection of ducts to match low crawl spaces without transition piece
• Utility Connections Made Easy – Gas and electric utility access provided through the bottom or the side of the unit
• Utility connections can be made quickly and with a minimum amount of field labor
• A field supplied and field installed electrical disconnect switch must be installed
• Convertible Airflow Design – The bottom duct openings are covered when they leave the factory, ready to be used for a side supply/side return application
• If a bottom supply/bottom return application is desired, simply remove the two panels from the bottom of the unit and place them in the side supply/side return duct openings
• No panel cutting is required and no accessory panel is necessary
• Convertible airflow design allows maximum field flexibility and minimum inventory
• Condensate Pan – A corrosion-resistant, long-lasting, water-tight pan is positioned below the evaporator coil to collect and drain all condensate, preventing build-up of stagnant condensate
• The condensate pan conforms to ASHRAE 62-89 standards (Ventilation for Acceptable Indoor Air Quality)
• Condensate Drain – The 3/4 inch NPT female connection is rigidly mounted to assure proper fit and leak tight seal
• Durable Finish – The cabinet is made of G90 galvanized steel with a powder paint coating for appearance and protection
• The pre-treated galvanized steel provides a better paint-to-steel bond, which resists corrosion and rust creep
• Powder paint finish insure less fading when exposed to sunlight and provides superior corrosion resistance (1000 hour salt spray tested)
• Full Perimeter Base Rails – The easily removable base rails provide a solid foundation for the entire unit and protects the unit during shipment
• The rails provide fork lift access from all sides, and rigging holes are also provided so that an over-head crane can be used to place the units on a roof
• On applications where the unit is placed on a pad, the base will keep the unit off the pad to deter corrosion
• On applications where height is limited, the base rails may be removed by removing 2 screws in each corner
• More Attractive Appearance – A single-piece top cover containing a top-discharge outdoor fan arrangement requires less square footage on installation and provides a wider variety of installations
• The one-piece design adds greater water integrity
• Rounded corners with water drip edges add to the attractive appearance
• Top Discharge – The top-discharge outdoor fan does not disrupt neighboring areas or dry out vegetation surrounding the unit

Specifications:

BtuH Cooling: 56500

BtuH Heating Input: 100000

BtuH Heating Output: 80000

Depth: 51.25 inches

EER: 11.2

Height: 50″

Minimum Circuit Amps: 36.5

Non CFM: 1810

Nom Tons: 5

Phase: Single

Refrigerant: R410A

SEER: 14

Volts: 208/230V

Width: 35.75 inches

Weight: 475 pounds